Enviro Sonnet C-11253 - Manual (Page 12)

Maintenance And Service
G
LASS
D
OOR
R
EMOVAL
:
C
LEANING
T
HE
P
AINTED
S
URFACES
:
Painted faces should be wiped with a damp cloth periodically.
R
EPLACING
T
HE
B
ATTERIES
:
It is recommended that the batteries are replaced at the beginning of each heating season. Batteries
must be changed when an acoustic error message is heard. Do not use metallic tooling to remove the
batteries as it could cause a short that may render the receiver inoperable.
Table 3: Batteries Required for Sonnet.
Quantity Type of Battery
Receiver 4
1.5V “AA” (quality
alkaline recommended)
Remote
Handset
1
9V (quality alkaline
recommended)
Remote Handset:
Remove handset backing, replace the 9V battery, and re-
install handset backing (see Figure 13).
Receiver:
IMPORTANT: Do not put batteries directly in the receiver.
1. For fan units only - Unplug the power or turn off the
electrical breaker for the unit.
Warning: Do not touch or attempt to remove the glass if the fireplace
is not completely cold. Never operate the fireplace with the glass
removed.
CAUTION GLASS MAY SEPARATE FROM DOOR.
Figure 10: Door Release.
Figure 11: Door Removal.
Remove the glass door by placing the
hooked end of the door release tool in
the hole on the door latch mechanism
(see Figure 10) and pulling the latch
out then up over the lip on the door.
When the two (2) latches have been
released, tilt the door forward and then
lift up to unhook the bottom door tabs
(see Figure 11).
2. Pull the right end of the control panel forward; it will pivot out (see Figure 12). The battery pack for
the receiver is mounted to the same bracket as control panel
3. Replace the four (4) 1.5V “AA” batteries.
4. Push the control panel back into place.
5. Plug the unit in or turn on the electrical breaker for the unit.
Figure 12: Control Panel & Battery Pack
Bracket.
12