Enviro Sonnet C-11253 - Manual (Page 14)

Warning: This conversion kit shall be installed by a qualified service agency in accordance
with the manufacturer’s instructions and all applicable codes and requirements of the
authority having jurisdiction. If the information in these instructions is not followed
exactly, a fire, explosion or production of carbon monoxide may result causing property
damage, personal injury or loss of life. The qualified service agency is responsible for
the proper installation of this kit. The installation is not proper or complete until the
operation of the converted appliance is checked as specified in the manufacturer’s
instructions supplied with the kit.
Maintenance And Service
R
EMOVING
V
ALVE
C
OVER
:
The valve cover can be removed to access the gas valve, the fan, wiring harness, or other components.
1. Remove the glass door as shown in the
M AINTENANCE AND S ERVICE - G LASS D OOR
R
EMOVAL .
2. Carefully remove the log set, ember
material, and brick panels, refer to
S
ECONDARY
I
NSTALLATION
- B
RICK
P
ANEL
I NSTALLATION and S ECONDARY I NSTALLATION
- L
OG
S
ET AND
E
MBER
I
NSTALLATION
.
3. Using a T-20 screwdriver remove the two
(2) screws that hold the burner tray in
place (pointed out in Figure 17). Pick up
the burner tray at the front (see Figure 18)
then pull it out of the firebox.
4. Using a T-20 screwdriver remove the six
(6) screws that hold the valve cover in
place (pointed out in Figure 19). Pick the
valve cover up then out of the firebox (see
Figure 20).
Figure 17: Screws Holding Burner Tray in Place.
Figure 19: Screws Holding Valve Cover in Place.
Figure 18: Removing Burner Tray.
Figure 20: Removing Valve Cover.
14
F
UEL
C
ONVERSION
:
TO BE INSTALLED BY A QUALIFIED SERVICE AGENCY ONLY
Please read and understand these instructions before installing.