Enviro Sonnet C-11253 - Manual (Page 34)

B
RICK
P
ANEL
I
NSTALLATION
:
NOTE: The brick liner is fragile and should be handled gently.
1. Ensure the Sonnet is turned off and allow the unit to cool.
2. Remove the glass door as shown in the M
AINTENANCE AND
S
ERVICE
- G
LASS
D
OOR
R
EMOVAL
.
Warning: Do not touch or attempt to remove the glass if the fireplace is not completely cold. Never
operate the fireplace with the glass removed.
3. Remove the log set and all ember material.
4. Choose which brick pattern you would like to face
out.
5. There is a ledge at the back of the firebox (see
Figure 69). Place the back brick panel on the ledge
and ensure the panel is flush at the bottom and top
(refer to Figure 70). Do not push at the center of the
panel.
6. Slide the front of the left brick panel into the left lip
at the front of the firebox. Ensure the panel is flush to
the side of the firebox and the back brick panel while
still being hooked behind the front lip (refer to Figure 71). Take care to not bump the brick panel on
the burner.
7. Repeat step 6 for right brick panel.
8. Install the log set and ember material (refer to S
ECONDARY I NSTALLATION - L OG S ET AND E MBER
I
NSTALLATION
) and the glass door.
Figure 70: Back Brick Panel in Place.
Figure 69: Back Brick Panel Ledge.
Figure 71: Side Brick Panels in Place.
Hook the Andiron assembly over the two (2) bushings at either side
of the bottom of the Sonnet (see Figure 68) and snap them firmly
down into place. When in place it will look similar to the image on the
front cover of this Sonnet Owner’s Manual.
Note: The mounting brackets may need to be adjusted to fit onto the
bushings. Loosen the screws on the brackets, adjust the brackets,
and then re-tighten the screws.
Figure 68: Hook Placements.
Secondary Installation
O
PTIONAL
C
AST
A
NDIRON
& G
RATE
:
34