Enviro Sonnet C-11253 - Manual (Page 25)

25
Initial Installation
QUALIFIED INSTALLERS ONLY
E
LECTRICAL
R
EQUIREMENTS
:
The fan will not operate if the appliance is cold. A few minutes after the appliance is lit and the fan is set
to low or high, the fan will automatically turn on. The fan will automatically turn off after the appliance
has cooled down.
Fan Control
Black
White Grey
Green
Black
Power Cord
120V AC
FAN
120 o F (49 o C)
Temperature Sensor
CNT1 CNT4
CNT2 CNT3
Low High
Grey
CNT5
Black
CNT6 CNT8
CNT7
CNT9
The fireplace must be electrically connected and
grounded in accordance with local codes or, in
the absence of local codes, with the current CSA
C22.1 Canadian Electrical Code Part 1, Safety
Standards For Electrical Installations, or The
National Electrical Code ANSI / NFPA 70 in the
US.
WARNING: The electrical grounding instructions
must be followed. The fan kit is equipped with a
three-prong (grounding) plug for your protection
against shock hazard, and should be plugged
directly into a properly grounded three-prong
outlet. DO NOT cut or remove the grounding
prong from this plug.
CAUTION: When servicing controls, label all
wires prior to disconnection. Wiring errors can
cause improper and dangerous operation. Verify
proper operation after servicing.
Figure 45: Wiring of a valve.
Figure 44: Fan wiring diagram.