Silvercrest SFB 10.1 C3 - Manual (Page 18)

SilverCrest SFB 10.1 C3
16 - English
3. Press , select “CODE SET” and press to confirm.
4. Then press the device button or that you wish to
program and press to confirm.
5. The first digit of the 4-digit device code currently set flashes.
6. Enter the correct 4-digit code for the selected device using the
number buttons, then enter the number of the corresponding code list
(0 to 7) and press
to confirm.
7. Press to confirm the entry. The display reads “SUCCESS”
followed by “CODE SET”.
8. Invalid CODES cannot be found in the CODE list. If you enter an
invalid code “NOT FOUND” appears on the display and you can
then enter the correct code.
Press to go back one menu level. To return to the start window,
press one of the device buttons. On the left of the time the code assigned
to the device button
or is shown on the display. The
selected code list (0 to 7) is also displayed to the left of the day of the
week.
Before you can program the device buttons or using the
brand code search or automatic search, it is necessary to assign the code
list to the device button. To do so, proceed as described in the previous
section, select the number 0001 as your code and select the number of
the desired code list (0 to 7). This assigns the code list to the device
button
or so you can proceed with programming.
At this point, programming the device buttons or works
the same way as described in the “Automatic code search (AUTO
SRCH)” and “Brand code search (BRAND SRCH)” chapters.
System configuration (CONFIGURE)
Setting the time (TIME SETUP)
1. Press and hold the button for 3 seconds.
2. Press , select “CONFIGURE” and press to confirm.
3. Press , select “TIME SETUP” and press to confirm.
4. Press , select between “12HR” and “24HR”.
5. Press to toggle to time setting mode. The hour display flashes.
6. Press and select the correct value for the hour. You
can also adjust the value by using the numeric keypad (11).
7. Press to toggle to minute setting mode.
8. Press and select the correct value for the minutes. You
can also adjust the value by using the numeric keypad (11).
9. If you selected “12HR” in step 4, you can press to select the
PM/AM setting. Press to toggle between PM and
AM.
10. Press to confirm your entry and save the setting. The display
reads “SUCCESS” followed by “TIME SETUP”.
Press to go back one menu level. To return to the start window,
press one of the device buttons.