Silvercrest SFB 10.1 C3 - Manual (Page 26)

SilverCrest SFB 10.1 C3
24 - English
1. Press and hold the button for at least 3 seconds.
2. Press , select “TIMER” and press to confirm. The
display reads “SLEEP TIMER”.
3. Press , select a desired timer from “TIMER1” to
“TIMER4” and press to confirm. The display shows a 4-digit time.
The first two digits representing the hour flash. Here, you set the time
at which you want the command sequence to be sent.
4. You can use the number buttons to set a time from 00:00 to 23:59.
Use the buttons to toggle between the 4 digits, e.g. to correct
any mistakes. Press to confirm the set time.
The timer is always set in 24-hour format. If you have set
the remote control preferences to the 12-hour format,
please note the following:
In this case the remote control automatically converts the
24-hour format to the 12-hour format. Example: To
program a timer for 03:30PM, enter 15:30.
5. Next press the device button for the device you want and then enter
the command sequence (max. 14 buttons) that you want to send at
the set time.
It is necessary to press a device button before entering a command
sequence, otherwise the display reads “ERROR KEY”.
6. By default, the different timer commands are transmitted sequentially
every second. As this could be too fast for some devices, you can
adjust the delay time in 2-second increments from 5 to 21 seconds.
To do so, press the button, more than once, if necessary. The
current delay time is indicated on the display.
7. When you are done, press to confirm your entry. The display
reads “SUCCESS”.
8. You can press up to 15 buttons per event timer, including the device
button. After this, the programming is applied automatically and the
display reads “SUCCESS”.
9. If required, you can program more event timers.
10. When an event timer is programmed, the
icon appears on the left
of the display.
After an event timer has completed it is erased automatically.
Press to go back one menu level. To return to the start window,
press one of the device buttons.
Deleting a timer
To delete a programmed timer (“SLEEP TIMER”, “TIMER1” to “TIMER4”):
1. Press and hold the button for at least 3 seconds.
2. Press , select “TIMER” and press to confirm.
3. Select the timer that you wish to delete and press to confirm. The
display reads “CLEAR”. Press to confirm. The display reads
“SUCCESS”. The selected timer is deleted. The display shows the
name of the selected timer (“SLEEP TIMER”, “TIMER1” to “TIMER4”).
Press to go back one menu level. To return to the start window,
press one of the device buttons.