Silvercrest SFB 10.1 C3 - Manual (Page 23)

SilverCrest SFB 10.1 C3
English - 21
7. Press to confirm. The display reads “DELETED” and then again
“SELECT KEY”.
8. Repeat steps 6 and 7 for each button for which you wish to delete
the code.
Press to go back one menu level. To return to the start window,
press one of the device buttons.
Deleting the device codes of an individual device (DELETE
DEV)
This function allows you to delete all learned codes for a selected device.
1. Press and hold the button for 3 seconds.
2. Press , select “LEARNING” and press to confirm.
3. Press , select “DELETE DEV” and press to confirm.
4. The display reads “SELECT DEV”.
5. Press the device button of the device for which you want to delete
the code. The display reads “SURE DELET”.
6. Press to confirm. The display reads “DELETED” and then again
“SELECT DEV”.
7. Repeat steps 5 and 6 for each device for which you wish to delete
the codes.
Press to go back one menu level. To return to the start window,
press one of the device buttons.
Deleting all button codes (DELETE ALL)
This function allows you to delete all learned codes for all devices at
once.
1. Press and hold the button for 3 seconds.
2. Press , select “LEARNING” and press to confirm.
3. Press , select “DELETE ALL” and press to confirm.
The display reads “SURE DELET”.
4. Press to confirm. The display reads “DELETED” and then again
“DELETE ALL”.
Press to go back one menu level. To return to the start window,
press one of the device buttons.
The macro function (MACRO)
The macro function lets you save up to 16 commands for a device that
will be sent in sequence when pressing one single button.
Example: Power on TV > Select channel 11 > Display Teletext > Open
Teletext page 222.
Programming a macro
1. Press and hold the button for 3 seconds.
2. Press , select “MACRO” and press to confirm.
3. Press , select "MACRO1“ (or "MACRO2“…..
"MACRO6“ and press to confirm.
4. The display reads “SET UP”. Press to confirm.
5. If you select a macro that already has a command sequence
assigned, the display reads “MACRO HAS”. In this case you have to
delete this macro before entering commands or select a different,
free macro.
6. The device currently selected is shown.