Silvercrest SFB 10.1 C3 - Manual (Page 24)

SilverCrest SFB 10.1 C3
22 - English
7. Enter the button commands sequence you want. Always start with the
device button of the device you want to record the macro for,
otherwise the message “ERROR KEY” appears.
8. By default, the different macro commands are transmitted
sequentially every second. As this could be too fast for some devices,
you can adjust the delay time in 2-second increments from 5 to 21
seconds.
9. To do this, press the button after a button command. Each press
of the button delays the pause time after the last command for 2
more seconds and the set value is shown on the display.
10. After you have finished entering the command sequence, press
. The display reads “SUCCESS”.
You can press up to 16 buttons per macro, including the device button.
After this, the macro is applied automatically and the display reads
“SUCCESS”.
Press to go back one menu level. To return to the start window,
press one of the device buttons.
Running a macro
1. Press the button.
2. Within the next 5 seconds, press the number button 1 to 6 which
corresponds to the macro you want.
3. The command sequence programmed for this macro is sent.
If you do not press the corresponding number button within 5 seconds
after you press the button or if you press a wrong button that has no
macro assigned, the remote control light flashes 4 times.
Deleting a macro
1. Press and hold the button for at least 3 seconds.
2. Press , select “MACRO” and press to confirm.
3. Press , select "MACRO1“ (or "MACRO2“…..
"MACRO6“ and press to confirm. The display reads “SET UP”.
4. Press , select “DELETE” and press to confirm. The
display reads “SURE DELET”.
5. Press to confirm. The display reads “DELETED”. The selected
macro is shown again on the display.
Press
to go back one menu level. To return to the start window,
press one of the device buttons.
Configuring favourite channels (FAV CH)
This function is supported in the modes TV, DSAT, CBL and AUX (if the
AUX device button has been programmed accordingly) only You can
save preferred channels as favourites.
Setting up favourites
1. Press the device button for the device that you wish to program.
2. Press and hold the
button for at least 3 seconds.
3. Press , select “FAV CH” and press to confirm.
4. Press , select “CONFIGURE” and press to confirm.
The display reads FAV-CH01.
5. Press , select “FAV-CH01” (or “FAV-CH02”….. “FAV-
CH15”) and press to confirm. The display reads “SELECT KEY”.
6. Enter the channel that you wish to save. You can save up to 6 entries
(digits or -/- -) per channel preset. The entered digits are not shown