Edimax Technology i-Watcher Pan/Tilt Internet IP Camera - Manual (Page 29)

12. Hardware Reset Function
Use Pin to push Reset button hole 10 sec, the
Camera will reset , mean is all setup value back
To factory default.
When you want to reset camera, the camera
must in Power on status.
When you need use reset button ?
z Lose of administrator password
z Incorrect network configuration
z
To reset the i-WATCHER IP-Camera
z
To reset IP address for LAN or WLAN
z
Make sure the i-WATCHER is power on.
z
There is a small reset hole at the side of the i-WATCHER
z
Insert an object to depress the reset button inside the hole
z Depress the reset button for 5 seconds and the i-WATCHER will automatically
z Reset itself back to the default factory setting.
13. Accessing i-WATCHER over the Internet
If your home or business LAN is connected to the Internet through a high speed (broadband)
Internet connection, with at least 128 kbps upload bandwidth, you can access your
cameras via the web browser from anywhere on the Internet. To do this you would need to:
1. Know your WAN (Internet) IP address. This is the IP address that your Internet Service
Provider provides you to access the Internet. It may be static (always the same) or
dynamic (can change from time to time).
2. Make sure the two ports used by the camera (80 & 1600) are forwarded by your router
or gateway to the camera.
3. Make sure your camera default gateway is set to the LAN (local) IP address of your
router/gateway.
13-1. WAN IP Address
The WAN (Wide Area Network) IP address that your Internet Service Provider provides you
so that you can access the Internet is very different from the LAN or local IP address that
your PCs and cameras are using to connect to your local network. Your WAN or Internet IP
address is visible to the outside world (Internet) whereas your local addresses are not. To
find your home or business network from the Internet you must know your WAN IP address.
Your WAN IP address is stored by your gateway router, which uses it to connect to the
Internet. All the devices on your network connect to the Internet via your gateway router.
You can find your current WAN IP address by checking your router status page. There are
also various websites such as www.whatismyip.com which will tell you the IP address that
you are currently using to access the Internet.
29