Edimax Technology i-Watcher Pan/Tilt Internet IP Camera - Manual (Page 32)

14-2. Using PING
PING is a very useful utility for
checking to see if a camera is
responding or checking to see
if an IP address is available.
In Windows 98/Me,
PING is located in C: \Windows.
In Windows 2000/XP,
PING is located in C: \Windows\System32.
Windows 98/Me/2000/XP:
1. Click on Start ->Run and type in: command and then press ENTER
2. In the MS- DOS window, type in: ping XXX.XXX.XXX.XXX and then press ENTER
3. (where XXX.XXX.XXX.XXX is your IP address) For example, if your Camera uses the IP
address of 123.123.123.1, you would type in: ping 123.123.123.1
If there is a camera, or a PC or other network device online and using this address you
will see:
Pinging 123.123.123.1 with 32 bytes of data:
Reply from 123.123.123.1: bytes=32 time<1ms TTL=128
Reply from 123.123.123.1: bytes=32 time<1ms TTL=128
Reply from 123.123.123.1: bytes=32 time<1ms TTL=128
Reply from 123.123.123.1: bytes=32 time<1ms TTL=128
Ping statistics for 123.123.123.1:
Packets: Sent = 4, Received = 4, Lost = 0 (0% loss),
Approximate round trip times in mill-seconds:
Minimum = 0ms, Maximum = 0ms, Average = 0ms
If there is NO response on this address you’ll see
Pinging 123.123.123.1 with 32 bytes of data:
Request timed out.
Request timed out.
Request timed out.
Request timed out.
Ping statistics for 123.123.123.1:
Packets: Sent = 4, Received = 0, Lost = 4 (100% loss),
This indicates that the address is available for use. However, there could still be a device
which is currently offline which is configured to use the address. To be certain, make sure
all your network devices are on and connected to your network when checking for address
availability.
14-3. IP Edit
IP EDIT.EXE is used to scan the Installed i-WATCHERs and set the Camera Name and IP
Address.
32