Epson PictureMate PM290 - Manual (Page 5)

PictureMate PM 260 / PM 290 Safety Instructions 5
Englis
h
❏
Leave enough room around the printer to allow for sufficient
ventilation.
❏
Place the AC adapter near a wall outlet where the plug can
be easily unplugged.
❏
Do not place or store the printer and the AC adapter
outdoors.
When setting up your printer
Observe the following when setting up the printer:
❏
Do not block or cover the vents and openings in the printer.
❏
Power supply cords should be placed to avoid abrasions,
cuts, fraying, crimping, and kinking. Do not place objects
on top of power-supply cords and do not allow the AC
adapter or power-supply cords to be stepped on or run over.
Be particularly careful to keep all power-supply cords
straight at the ends and the points where they enter and
leave the AC adapter.
❏
Use only the power-supply cords that comes with this
product. Use of another cord may result in fire or electrical
shock, or injury.
❏
The AC adapter model A381H is designed for use with the
printer with which it was included. Do not attempt to use it
with other electronic devices unless specified.
❏
Use only the type of power source indicated on the AC
adapter's label, and always supply power directly from a
standard domestic electrical outlet with the AC power cord
that meets the relevant local safety standards.
w
Warning:
Refer to the rating plate for the voltage and
check that the appliance voltage
corresponds to the supply voltage.
❏
Avoid using outlets on the same circuit as photocopiers or
air control systems that regularly switch on and off.
❏
Avoid using electrical outlets controlled by wall switches or
automatic timers.
❏
Keep the entire computer system away from potential
sources of electromagnetic interference, such as
loudspeakers or the base units of cordless telephones.
❏
Do not use a damaged or frayed power cord and the AC
adapter.
❏
If you use an extension cord with the printer, make sure that
the total ampere rating of the devices plugged into the
extension cord does not exceed the cord's ampere rating.
Also, make sure that the total ampere rating of all devices
plugged into the wall outlet does not exceed the wall outlet's
ampere rating.
❏
Never disassemble, modify, or attempt to repair the AC
adapter, power cord, printer, and options by yourself except
as specifically explained in the printer's guides. Doing so
may result in injury, electric shock, or fire.