Edirol UA-1000 - Manual (Page 19)

19
Preparations for using the UA-1000
7
Prepare the CD-ROM.
Insert the CD-ROM into the CD-ROM drive of your computer.
8
Click the Windows start button. From the menu that appears, select
“Run...”
The “Run...” dialog box will appear.
fig.2-3
9
In the dialog box that appears, input
the following into the
“Open” field,
and click [OK] .
(drive name) :\Driver\USB_XP\SETUPINF.EXE
* In the explanatory example shown here, the drive name is given as “D:” . The drive name
“D:” may be different for your system. Specify the drive name of your CD-ROM drive.
10
The SetupInf dialog box will appear.
You are now ready to install the driver.
11
Use the USB cable to connect the UA-1000 to your computer.
1. With the power switch turned OFF , connect the power cord to the UA-1000 .
2. Connect the power cord to an electrical outlet.
3. Use the USB cable to connect the UA-1000 to your computer .
12
Set the UA-1000’s power switch to the ON position.
Near the task bar, your computer will indicate “Found New Hardware.” Please
wait.
13
The Found New Hardware Wizard will appear.
Select “Install from a list or specific location (Advanced),” and click [Next] .
If the screen indicates
“Windows can perform the
same action each time you
insert a disk or connect a
device with this kind of file,”
click [Cancel].
To check the drive name
Click the start button, and
choose My Computer from the
menu that appears. In the
window that appears, check
the drive name of the CD-
ROM drive into which you
inserted the CD-ROM in step
7. The drive name is the (D:) or
(E:) displayed by the CD-ROM
drive .
Once the connections have
been completed, turn on
power to your various devices
in the order specified. By
turning on devices in the
wrong order, you risk causing
malfunction and/or damage to
speakers and other devices.
This unit is equipped with a
protection circuit. A brief
interval (a few seconds) after
power up is required before
the unit will operate normally.
UA-1000_e.book 19 ページ ２００３年８月６日 水曜日 午前１１時５２分