Edirol UA-1000 - Manual (Page 35)

35
Basic connections and settings
Using an external device as the master
In the setup shown here, the hard disk recorder or other external device is the master, and the UA-1000 is the
slave.
fig.synchro-slave
● Connections
Connect your external device (e.g., hard disk recorder) to the WORD CLOCK IN jack.
● Sampling frequency select switch
Set this to the same sampling frequency as selected for the master device.
● External clock switch
Turn this on (lit) so that the UA-1000 will synchronize to the digital signal input to the WORD CLOCK IN
connector (i.e., the UA-1000 will be the slave).
Hard disk recorder, etc.
Set the sampling frequency
WORD CLOCK
IN
Match the sampling frequency of
the master device ON (lit)
UA-1000_e.book 35 ページ ２００３年８月６日 水曜日 午前１１時５２分