Edirol UA-1000 - Manual (Page 44)

44
System settings
Restoring the factory settings (Factory Reset)
fig.system
1. While simultaneously holding down the output volume select
switch and the STEREO/MONO select switch , turn on the
power.
The output volume select switch and the STEREO/MONO select
switch will blink.
2. Press the STEREO/MONO select switch once again.
The output volume select switch and the STEREO/MONO select switch will blink faster, and then the direct
monitor soft control switch (SOFT CTRL) will light.
(The operation will be cancelled if you press any LED switch other than the STEREO/MONO select switch .)
Once the direct monitor soft control switch (SOFT CTRL) has lighted, the output volume select switch and
the STEREO/MONO select switch will go out.
The factory settings have now been restored.
Factory settings
* For details of the UA-1000's internal block structure when it is shipped from the factory, refer to “Block
diagram” (p. 51).
Function State
STEREO/MONO select switch STEREO
Direct monitor soft control switch On
ADAT Off
EXT CLOCK Off
Output volume mode MAIN
Hold down simultaneously
and turn on the power
UA-1000_e.book 44 ページ ２００３年８月６日 水曜日 午前１１時５２分