Riello UPS Sentinel Dual (High Power) (3.3 - 10 kVA) - Manual (Page 71)

71
U
SE
Measurements display area
The most important measurements relating to the UPS can be shown in sequence on the display.
When the UPS is started up, the display shows the value of the mains voltage.
To go to a different display press the “SEL/SET” button repeatedly until the required measurement is
displayed.
If a fault/alarm (FAULT) or a lock (LOCK) should occur, the type and corresponding alarm code is
automatically shown on the display.
Single phase version
Some examples are shown below:
(1)
The values shown in the images in the table are purely indicative.
(2)
The FAULT/LOCK codes can only be displayed if they are active (i.e., if there is a fault/alarm or a lock).
GRAPHIC EXAMPLE
(1)
DESCRIPTION
Mains voltage
Mains frequency
Voltage output from the
UPS
Output voltage frequency
Residual battery back up
time
Percentage of battery
charge
GRAPHIC EXAMPLE
(1)
DESCRIPTION
Total battery voltage
Percentage of the applied
load
Current absorbed by the
load
Temperature of the
cooling system for the
UPS internal electronics
Fault/Alarm
(2)
: the
corresponding code is
displayed
Lock
(2)
: the
corresponding code is
displayed