Rose Electronics Orion X-series - Manual (Page 41)

37 ORION XTENDER INSTALLATION AND OPERATIONS MANUAL
SETUP
System Setup
First time users are recommended to setup the system with the Transmitter unit and the Receiver unit in the
same room as a test setup. This will allow you to identify and solve any cabling problems, and experiment with
your system more conveniently. Please verify that interconnect cables, interfaces, and handling of the devices
comply with the requirements.
KVM Extender Setup
1. Switch off all devices.
Receiver Unit Installation
2. Connect your monitor(s), keyboard and mouse to the Receiver unit.
3. Connect the Receiver unit with the interconnect cable(s).
4. Connect the 5VDC power supply to the Receiver unit.
Transmitter Unit Installation
5. Connect the source (computer, CPU) to the supplied cables to the Transmitter unit. Please ensure the
cables are not strained.
6. Connect the Transmitter unit to the interconnect cable(s).
7. Connect the 5VDC power supply to the Transmitter unit.
8. Power up the system.
To power up the system, the following sequence is recommended:
Monitor – Receiver unit – Transmitter unit – source.
Setup of Upgrade Modules
The modules can be hot plugged.
Upgrade Module Analog Audio / Serial:
1. Connect the audio source with the Transmitter unit (e.g. CPU audio output with Transmitter audio input,
CPU audio input with Transmitter audio output).
2. Connect the audio output at the Receiver unit with headphones or suitable speakers.
3. Connect the audio input at the Receiver unit with a suitable microphone.