Sandia 12-Gallon, 1200 PSI Hard Surface Extractor - Manual (Page 12)

(12) 1200 PSI Hard Surface Extractor 1200 PSI Hard Surface Extractor (29)
4.1 Water and Chemical Dilution – Auto Fill Continued
Water Supply
Once the correct metering tip is in place:
• Connect the auto-fill water supply hose to the water inlet (the male QD on the front of
the machine).
• Connect the other end of the hose to a water faucet and then turn the water ON.
• Hot water can be used as long as it does not exceed 140 degrees Fahrenheit.
4.2 Connection of Solution Hose
Connect the high pressure solution hose to the solution outlet (female QD on the front
of the machine). Connect the other end of the hose to the male QD on the cleaning tool.
When you are ready to start cleaning, turn the solution pump switch to the ON position.
Chemical Feed Hose
Connect the auto-fill water supply
hose to solution inlet (male QD on
the front of the machine).
Connect the auto-fill water supply
hose to a faucet and turn water
ON.
Connect the male end of the HP
solution hose assembly to the
female solution outlet fitting on
the machine. Connect the female
end to the cleaning tool.
HP Solution Hose Assembly
Part No. 80-0502
25-Foot with Male and Female
Quick Disconnects
9.0 Wiring Diagram