EverFocus EMV200 - Manual (Page 75)

68
Note: If you have a dynamic IP address, you can set the DVR to DHCP to automatically detect the
network settings. Therefore, it can use a dynamic IP address.
Exit from the DVR’s Menu to save the settings.
To access the DVR from a computer, open Internet Explorer and in the address bar type:
http:// (IP address given by your internet service provider)
Note: When using this type of connection, only one device can be connected to the modem at a time.
You will need to use a computer at a different location to test the connection.
5.9 Router or LAN Connection
Straight Through Ethernet Cable Pin outs:
The Figure below (next page) shows the pin configurations for a straight cable.