Amprobe ACD-30P Clamp-On-Power-Meters - Manual (Page 12)

11
battery Replacement (see fig. 11)
� Warning
To prevent electrical shock or meter damage, disconnect the meter’s test leads from any
circuit and the meter, then turn the meter off before removing the battery cover. Battery
replacement should be performed in a clean environment and with appropriate care taken
to avoid contaminating the meter’s interior components.
Remove the screws and lift the battery cover.
Replace the batteries with the same type (1.5V AAA). note polarity guide below the
battery.
Replace the battery cover and screws.
SPECIfICAtIoNS
general
Display :
Voltage functions: 6000 counts lCD display(s)
Power, ohm & hz functions: 9999 counts lCD display(s)
ACA clamp-on function: 4000 counts lCD display(s)
Update Rate :
Power function: 1 per second nominal
Voltage, ACA clamp-on, ohm, hz & Temperature functions: 4 per second nominal
Polarity : Automatic
operating temperature : 0°C to 40°C; < 80% Rh @ < 31°C; decreasing linearly to 50% Rh
@ 40°C
Altitude : indoor operation, below 2000m.
Storage temperature : -20°C to 60°C, < 80% R.h. (with battery removed)
temperature Coefficient : nominal 0.15 x (specified accuracy)/ °C @ (0°C -18°C or 28°C
-40°C)
Sensing : True RMS sensing
Power Supply : standard 1.5V AAA Size (ne DA 24A or ie C lR03) battery x 2
Low battery : Below approx. 2.4V
Power Consumption :
Voltage, ACA, hz & Power functions: 10mA typical
ohm & Temperature functions: 4mA typical
APo timing : idle for 17 minutes
APo Consumption : 10μA typical
Jaw opening & Conductor diameter : 45mm max
Dimension : 224 x 78mm x 40mm (8.9 x 3.1 x 1.6 in.)
Weight : 224 gm approx
Safety lVD: Meets en60101-1:2001; en61010-2-032(2002), Category iii- 600 Volts ac & dc;
pollution degree : 2
1.
2.
3.