EMC QLogic - Manual (Page 42)

3
3-6 EMC Fibre Channel with QLogic HBAs in the Windows Environment
Configuring an EMC Boot Device
5. From the Configuration Settings menu, select Host Adapter
Settings and press ENTER .
6. From the Host Adapter Settings menu, select Host Adapter
BIOS and press ENTER to enable it if it is not already enabled.
Refer to EMC HBA Settings on page 2-8 for a table of EMC-approved
NVRAM settings.
7. Press ESC to exit the Configuration Settings menu.
8. From the Configuration Settings menu, select Selectable Boot
Settings and press ENTER .
9. From the Selectable Boot Settings menu, select Selectable Boot
Device and press ENTER to enable it if it is not already enabled.
10. Select Current Boot Node Name and press ENTER .
The adapter scans for attached storage devices, and displays them
on the screen.
11. Choose the storage array port from which you wish to boot. Its
entry will be similar to the following:
Select your boot device and press ENTER .
A list of LUNs will appear in a new window. Select the LUN from
which you wish to boot and press
ENTER .
12. Press ESC at the Selectable Boot Settings menu to return to the
Configuration Settings menu.
13. Press ESC at the Configuration Settings menu to return to the
Fast!UTIL Options menu.
Select Save Changes and press ENTER .
14. Press ESC to exit Fast!UTIL .
15. Reboot the host.
ID VENDOR PRODUCT REV NODE NAME Port ID
12 EMC SYMMETRIX 5566 50060482BFD06C02 0000E4
QLogic_Windows.book Page 6 Thursday, March 10, 2005 10:31 AM