Elation Professional 60TM - Manual (Page 11)

Design Wash LED 60™
©Elation Professional, Los Angeles Ca. 11 www.ElationLighting.com
12. 3-Pin DMX Output Jack – This jack is used to send an incoming DMX signal to the next
fixture in the DMX chain via a female, 3-pin XLR jack.
13. Battery On/Off Button – This button is used to turn the display menu on or off when the
fixture is not plugged into power. This feature will allow the fixture’s DMX address and
wireless setting to be set when the fixture is not connected to a power source.
14. 3-PIN DMX Input Jack – This jack accepts an incoming DMX signal via a male, 3-pin
XLR jack.
15. Fuse Holder Assembly – This assembly houses the 4amp GMA safety fuse. Always
replace the fuse with an exact match unless otherwise specified by an authorized Elation
Service Technician. Using a fuse other than that specified could seriously damage the
unit and will void your manufactures warranty.
16. Power Cord – Plug into an appropriate power outlet to provide main power to the
fixture.
17. 5-Pin DMX Output Jack – This jack is used to send an incoming DMX signal to the next
fixture in the DMX chain via a female, 5-pin XLR jack.
18. 5-PIN DMX Input Jack – This jack accepts an incoming DMX signal via a male, 5-pin
XLR jack.