Elation Professional 60TM - Manual (Page 26)

Design Wash LED 60™
©Elation Professional, Los Angeles Ca. 26 www.ElationLighting.com
sensitive to sound. This function only works in conjunction with the sound active
modes. The default setting is 70% and setting range from 0% to 99%.
8.4.2 Service Setting – The adjustments and settings in this section should only be
performed by a technician familiar with the functionality of fixtures of this type. Incorrect
adjustments to these functions may result reduced performance or damage to the
fixture.
Service Password: The correct password must be entered before attempting any
type of calibration or the changing fan voltage.
Fan Voltage: This function will change the fan voltage from either “Low” or “High.”
Low will send normal voltage to the fan, for normal operation. High will send slightly
higher voltage to fans that allows the fans to operate at higher than normal speeds.
This setting should only be used in extreme cases of higher than normal
temperatures. Using the fans in “HIGH” mode will decrease fan life over time. Low is
the default setting.
8.4.3 Fans Control - This function is used to change the functionality of the internal
cooling fans. The available selections are: 1) “AUTO” – The fans will automatically
switch between low and high speeds depending on the internal operating temperature. 2)
“HIGH” – The fans will run in high-speed mode regardless of operating temperature. 3)
“LOW” – The fans will remain in low speeds regardless of internal operating
temperature.
8.4.4 Display Setting – The display is designed to turn off during normal operation to
avoid excessive light in situations that require an extremely dark environment. This
function will adjust the time delay the LCD will remain on before it turns off. This function
is disabled as default.
8.4.5 Temperature C/F – This function changes the temperature the unit will display
from either Celsius or Fahrenheit. Celsius is set as default.