Kodak i2420 - Manual (Page 29)

A-61677 November 2016 23
Replacement
procedures
Kodak Scanners use replaceable tires that can feed a wide range of
document types, sizes and thicknesses. Tire life and performance will
vary based on the customer’s document set, the frequency of cleaning
the paper path and tires, and following the recommended schedule for
changing tires. Nominal tire life is approximately 125,000 pages. Usage
figures are not guaranteed. Customer-operating environments,
document type, the condition of documents being scanned, and not
following the recommended cleaning and replacement procedures, can
cause the life of the consumables to vary. You should change the tires if
you notice an increase in multiple feeds, stoppages, or a decrease in
feeder performance that is not resolved by following the cleaning
procedures.
NOTES:
• Before replacing parts, disconnect the electrical power.
• Certain paper types (such as carbonless paper or newsprint), failure
to clean regularly, and/or use of non-recommended cleaning solvents
can shorten roller life.
Replacing the separation
module and tires 1. Push the separation module up to snap it out and lift it out of
position.
• If you are replacing the separation module, insert the new
separation module by aligning the tabs with the slots and
snapping it into position.
• If you are replacing the tires, continue with Step 2.