Roland VC-100UHD 4K Video Scaler/Converter/Streamer - Manual (Page 15)

15
Audio Operations
Adjusting the USB Audio Signal
This configures the output level, equalizer and mastering effects for
the STREAMING port audio.
1 . Select Root menu “Processing” 0 “USB Streaming” 0
“Audio,” “Equalizer,” “Mastering” parameters.
2 . Turn the [VALUE] knob to set the parameter.
Parameter Explanation
Delay
If there is a timing discrepancy between the
video and audio, you can correct the output
timing by delaying the audio output.
Level Adjusts the output level.
Equalizer Enables/disables the equalizer.
Hi Freq
Specifies the center frequency when
changing the tone quality in the high band.
Gain Boosts or attenuates the high band.
Mid Q
Adjusts the width of the frequency band
when boosting or attenuating the middle
band.
Freq
Specifies the center frequency when
changing the tone quality in the middle band.
Gain Boosts or attenuates the middle band.
Low Freq
Specifies the center frequency when
changing the tone quality in the low band.
Gain Boosts or attenuates the low band.
Mastering Enables/disables the mastering.
Enhancer Adjusts the audio clarity.
Sense
Adjusts how much the mastering effects are
applied.
Level Adjusts the volume of the mastered sound.
3 . Press the [SETUP] button twice to return to the Root
menu screen.
Setting the Output Destination of the Analog
Audio Signal
This sets the signal to output from the AUDIO IN/OUT connector and
LINE OUT jacks.
1 . Select Root menu “Output” 0 “Analog Audio” 0
“Assign.”
2 . Turn the [VALUE] knob to set the output destination.
Value Explanation
SDI OUT CH. 1/2–15/16
Each channel of the 12G-SDI OUT
connector
HDMI OUT CH. 1/2–7/8
Each channel of the HDMI 4K OUT
connector
USB OUT CH. 1/2 STREAMING port
SDI IN CH. 1/2–15/16
Each channel of the 12G-SDI IN
connector
HDMI 2 CH MIX
Two channels are output, down
mixed with the audio from the
HDMI 4K IN connector.
USB IN CH. 1/2 STREAMING port
Analog IN CH. 1/2 LINE IN jacks
Analog IN CH. 3/4 AUDIO IN/OUT connector
Test Tone Outputs a test tone.
NONE Not assigned
3 . Press the [SETUP] button twice to return to the Root
menu screen.
Configuring the Audio Output