Roland VC-100UHD 4K Video Scaler/Converter/Streamer - Manual (Page 18)

18
Using the Memory
Formatting a USB Flash Drive
The first time that you use a USB flash drive, you must use the unit to
format it.
NOTE
5 A USB flash drive that was not formatted by this unit will not be
recognized.
5 Never turn off the power or remove the USB flash drive while the
message “Processing.” is shown.
5 When you format a USB flash drive, all data on that USB flash drive
is erased. If the drive contains important data, back it up to your
computer before you format the drive.
1 . Connect the USB flash drive to the USB HOST port.
2 . Select Root menu “System” 0 “Memory” 0
USB Memory “Format.”
3 . Press the [PAGE/CURSOR] knob.
Formatting is executed.
4 . Press the [SETUP] button twice to return to the Root
menu screen.
Saving
This saves all settings as a single file to a USB flash drive.
The settings are saved in the root directory with the “vc100uhd.bin”
filename.
1 . Select Root menu “System” 0 “Memory” 0
USB Memory “Save Settings.”
2 . Press the [PAGE/CURSOR] knob.
NOTE
Never turn off the power or remove the USB flash drive while the
message “Processing.” is shown.
3 . Press the [SETUP] button twice to return to the Root
menu screen.
Recalling
Loads the settings saved on a USB flash drive into this unit.
This overwrites all settings on this unit.
1 . Select Root menu “System” 0 “Memory” 0
USB Memory “Load Settings.”
2 . Press the [PAGE/CURSOR] knob.
NOTE
Never turn off the power or remove the USB flash drive while the
message “Processing.” is shown.
3 . Press the [SETUP] button twice to return to the Root
menu screen.
Saving the Unit’s Settings on a USB Flash Drive