Rear panel (connecting your equipment), Rear panel, Connecting your equipment) – Roland JUPITER-X Synthesizer User Manual
Page 11: Bac-in jack, C[ l ] switch, Dmidi (out/in) ports, Ectrl jack, Fhold jack, Gaux in jack, Hmic
JUPITER-X Owner's Manual Ver. 1.5 and later
11
B
AC-IN jack
Connect the included power cord here.
C
[
L
] switch
This turns the power on/off (p. 12).
D
MIDI (OUT/IN) ports
Used for connecting external MIDI devices and for transmission of
MIDI messages.
E
CTRL jack
Connect an expression pedal (EV-5; sold separately).
* Use only the specified expression pedal. By connecting any other
expression pedals, you risk causing malfunction and/or damage to the
unit.
F
HOLD jack
Connect a pedal switch (DP series; sold separately).
G
AUX IN jack
Connect an external audio device.
Use a stereo mini plug for this connection.
H
MIC
[MIC GAIN] knob
Adjusts the volume of the mic input.
MIC IN jack
Connect a dynamic
microphone or electret
condenser microphone (plug-in
power system) here.
* A condenser microphone
(phantom powered) cannot be
used.
I
OUTPUT L/R jacks
These are output jacks for audio signals.
J
OUTPUT (BALANCED) L/R jacks
These are output jacks for
audio signals.
K
PHONES jack
You can connect a set of headphones here.
L
USB port
USB MEMORY port
You can connect a USB flash drive here.
Connect or disconnect the USB flash drive while the JUPITER-X is
powered-off.
* Never turn off the power or disconnect the USB flash drive during a
process, such as while the
“Executing…”
display is shown.
USB COMPUTER port
Use a USB cable to connect this port to a USB port of your
computer.
This allows the JUPITER-X to operate as a USB MIDI device.
M
Ground terminal
* Connect this to an external earth or ground if necessary.
1: GND
2: HOT
3: COLD
※ 入力端子の場合
1: GND
2: HOT
3: COLD
※ 出力端子の場合
TIP: HOT
RING: COLD
SLEEVE: GND
Pin assignment of MIC IN jack
Pin assignment of OUTPUT (BALANCED) L/R jacks
1: GND
2: HOT
3: COLD
※ 入力端子の場合
1: GND
2: HOT
3: COLD
※ 出力端子の場合
TIP: HOT
RING: COLD
SLEEVE: GND
Rear Panel
(Connecting Your Equipment)
* To prevent malfunction and equipment failure, always turn down the volume, and turn off all the units before making any connections.
B
C
G
AUX IN jack
Connect an audio device.
L
USB port
I
OUTPUT jacks
K
PHONES jack
H
MIC
J
OUTPUT (BALANCED) jacks
E
CTRL jack
F
HOLD jack
Expression pedal (EV-5)
or
Pedal switch (DP series)
Mixer
Monitor speaker
(Amplifier built-in)
USB flash drive
Computer
Headphones
Dynamic microphone
Electret microphone
(mono)
D
MIDI ports
Connect a MIDI device.
M