Roland JUPITER-X Synthesizer - Manual (Page 5)

5
Introduction
Placing the JUPITER-X on a Stand
If you want to place the JUPITER-X on a stand, use the Roland KS-10Z or KS-12. Place the JUPITER-X on the stand as follows.
Be sure to follow the instructions in the Owner’s Manual carefully when placing this unit on a stand. If it is not set up properly, you risk creating an
unstable situation which could lead to the unit falling or the stand toppling, and may result in injury.
* Be careful not to pinch your fingers when setting up the stand.
KS-10Z
Adjust the horizontal width of the
stand as shown in the illustration.
Top view
Adjust so that the height
does not exceed 1 meter.
Align the front of the
JUPITER-X with the front of
the stand. 680 mm
KS-12
Adjust the width of the stand
so that the rubber feet on the
keyboard side of the bottom of
the keyboard fit into the holes
provided for the rubber.
Top view