Canon Speedlite 430EX III-RT - Manual (Page 62)

62
This section describes wireless (multiple flash) shooting using manual
flash. You can shoot with a different flash output setting for each slave
unit (firing group). Configure all the settings on the master unit.
1
Set the flash mode to < q >.
Press the < E > button of the
< S > cross keys of the master unit.
Turn < 9 > to select < R >, then
press < 8 >.
2
Set firing group control.
Press < 8 >.
Turn < 9 > to select the firing group
control symbol, then press < 8 >.
Turn < 9 > to select the group to be
fired, then press < 8 >.
< T > : Set all groups to the same
flash output
< U > : Set the flash output of A
and B
< V > : Set the flash output of A, B,
and C
3
Set the flash output.
Turn < 9 > to select the firing group
symbol, then press < 8 >.
Turn < 9 > to set the flash output,
then press < 8 >.
With < 5 > and < 7 >, repeat
steps 3 to set the flash output for all
groups.
4
Take the picture.
X Each group fires at the set flash ratio.
q : Wireless Multiple Flash Shooting with Manual Output
Firing group control
When < 8 > is set, set A, B, or C as the firing group for the slave units
(p.59). The flash will not fire if it is set to D or E.