BenQ IL5501 55" SmInteractive Signage Display - Manual (Page 23)

Connection 23
Connecting the touch module
The touch module of the display supports easy Plug-and-Play operation. There is no need
to install additional drivers on the computer.
1. Connect the
TOUCH-USB port on the display to the USB port of a computer using
the supplied USB cable and then connect the VGA , HDMI1 , HDMI2 , or DP port on
the display to the VGA, HDMI or DP output port on the computer using the corre-
sponding cables.
2. Press INPUT on the remote control and then select the interface through which the
display is connected to a computer.
• Avoid blocking the touch screen frame (where sensors are located) when initiating the touch
module.
• It is highly recommended that you connect the display to the PC or laptop directly. Avoid
connecting the display to a face plate device which may cause failures in touch operations.
• If any ghost image occurs, please try to un-plug and then re-plug all USB cables. If the failure
image still exists, use another USB type B to A cable.
D-Sub (15-pin)
cable
USB cable
HDMI cable
DP cable
Computer