Elmo HV-8000SX - Manual (Page 17)

- 16 -
Connection to the composite video-in terminal
Use the supplied RCA video/audio cable or a BNC cable available on the market.
AC IN
DC12V
MOUSE INPUT
S-VIDEO
VIDEO L AUDIO R
AUDIO
(L/R)1
AUDIO
(L/R)2 RGB OUT RGB2
RGB1
OUTPUT
ON
OFF
POWER
USB Ethernet
RS-232C
Monitor
AC IN
DC12V
Ethernet MOUSE INPUT
S-VIDEO
VIDEO L AUDIO R
AUDIO
(L/R)1
AUDIO
(L/R)2 RGB OUT RGB2
RGB1
OUTPUT
ON
OFF
POWER
USB
RS-232C
Liquid crystal projector
Monitor
Connection to the analogue RGB-in terminal
Connect the analogue RGB-out terminal [OUTPUT·RGBOUT] to the equipment
having an analogue RGB-in terminal with the analogue RGB cable (attached) or a
connection cable available on the market.
At this time, the position of the display may be deviated from the center. If deviated,
manually adjust the horizontal and vertical positions on the connected equipment side.
Also, vertical stripes may appear on the screen of the liquid crystal projector. That can
be alleviated by manually adjusting the dot clock frequency on the projector side.
Connection to the monitor and the projector
Note: Be sure to turn OFF the power supply to all equipment before making any
connections to protect the Presenter and all the connected equipment.
Note: When switching the I/O selection switch key, be sure to turn OFF the power
supply to the Presenter beforehand.
Note: Hold the cable plug when connecting or disconnecting the cables.
The following settings of the Presenter can be switched with the DIP switch. Switch the
settings according to the connection environment. The factory settings are as shown in
the following table:
Key
A
B
C
D
To switch the image output
To switch the TV output method
To switch the TV output screen size
To initialize the network function settings
Function
Key selection
Initial setting
0 SXGA output
NTSC
Over scan
Normal operation
0
0
0
Content