Elmo HV-8000SX - Manual (Page 20)

- 19 -
6. OPERATION PROCEDURES
(1) Turn ON the power switch.
Note: Before turning ON the power
switch, connection to the
monitor should have been
completed.
Note: When the power switch is
turned ON, the lighting unit
lights up.
Note: If the power switch is turned
ON immediately after being
turned OFF, the Presenter may
not operate. For restarting,
turn OFF the Presenter and
wait several seconds then turn
ON.
(2) Place the object on the stage. Adjust
the image size according to the
object size using the zoom buttons
([TELE] / [WIDE]) on the front
panel or the zoom buttons ([TELE]
/ [WIDE]) on the wireless remote
control, while watching the image
on the TV monitor.
(3) Press the auto focus button [AUTO
FOCUS] on the front panel or the
auto focus button [AF] on the
wireless remote control.
Note: The auto focus function works
up to a height of approx. 10cm
(3.9 in) above the stage
surface when the zoom button
[TELE] is set to the maximum.
Simple steps for presenting printed material
INPUT AF
TELE WIDE ZOOM
Front panel
Wireless remote control
Front panel
Wireless remote control