Emerson Radio iP500 - Manual (Page 21)

20
Listening To The Radio
1.) Press the Power button to turns the unit ‘On’. The display lighting and the
Power LED indicator come ‘On’.
2.) Press the Function button to select the Radio function.
The first time you select the Radio function the display will show:
“FM 87.5 MHz ST”.
Press the Function button once more to select
the AM band. The first time you select the AM band
the display will show “AM 520 KHz”.
3.) After selecting the desired band, tune to the desired station by either the
Automatic or Manual Tuning methods as follows:
• Manual Tuning
Repeatedly press the Tuning + ( ) / – ( ) buttons on the top panel or TUN
/ buttons on the remote control until the frequency of the desired
station appears on the display.
• Automatic Tuning
Depress and hold either the Tuning + ( ) / – ( ) buttons on the top panel or
TUN / buttons on the remote control until the display begins to move,
then release the buttons. The tuner will search up or down the band for the
next strong station and stop on that station. Repeat this procedure until the
tuner stops on the desired station.
NOTES:
A.) Use the Manual Tuning method to tune to weak stations that are bypassed
during Automatic Tuning.
B.) If you are listening to a very weak FM Stereo station, try pressing the
Mode button to select the FM MONO mode.
This will normally improve the reception
although the sound will no longer be in stereo.
iP500_042307.p65 23/4/2007, 17:00 20