Emerson Radio iP500 - Manual (Page 38)

37
Wake-up To iPod ®
NOTES:
• You cannot wake-up to an iPod ® Shuffle connected to the USB port. You
can only wake-up to ‘dockable’ iPod ® models that are connected to the
30-pin connector in the docking area.
• If you select the “Wake-up To iPod ® ” mode but there is no iPod ® connected
to the dock at the wake-up time, the system will automatically default to
the “Wake-up to Buzzer” mode.
1.) Make sure that the iPod ® is properly inserted in the docking area and that the
HOLD switch on the iPod ® is ‘Off’.
2.) Check and adjust the alarm time setting if necessary and make sure the
“ iPod” alarm mode is selected.
3.) Press the Alarm On/Off button to activate the alarm. Make sure the “ iPod”
icon appears in the display.
4.) At the selected wake up time the iPod ® will turn on automatically. It starts softly
and gradually gets louder.
It will continue to play for 60 minutes and then shut
off automatically until the following day.
5.) To stop the iPod alarm sooner, press the Alarm On/Off button once. The iPod ®
stops immediately but the “ iPod” indicator remains in the display and alarm
remains set for the following day.
To deactivate the alarm completely press the Alarm On/Off button once more.
The “ iPod” indicator disappears.
iP500_042307.p65 23/4/2007, 17:01 37