Emerson Radio iP500 - Manual (Page 28)

27
NOTE: If you are using either the 30GB or 60GB fifth generation iPod ®
models with video capability, or the 2G (Second Generation) iPod ® nano,
use the adapters that were supplied with the iPod ® s at time of purchase.
They will fit correctly in the docking cradle of this system.
IMPORTANT!
• If you are using a “1G (First Generation) iPod ® nano” you must slide the
docking connector to the ‘left’ position before inserting the required adapter
as shown in the following illustrations:
• If later you decide to install a different iPod ® model you must remove the
nano adapter from the docking cradle and slide the docking connector
back to the ‘right’ position before inserting the appropriate adapter.
3.) Slide your iPod ® into the adapter and make sure that it slides down as far as
possible until it is correctly seated on the iPod ® connector.
4.) Press the Power button of this system to turn the power ‘On’.
5.) Press the Function button of this system to select
the iPod function. The “iPod” indicator appears in
the display.
iP500_042307.p65 23/4/2007, 17:01 27