Emerson Radio iP500 - Manual (Page 25)

24
Adjusting The Digital Tuner For Use in Other Countries
The tuner in this system can be adjusted for the AM and FM bands and frequency
steps used in Europe and Japan in addition to the normal USA settings. The tuner
was set for the USA settings at our factory. If this system will be used in the USA
there is no need for you to make any adjustments. This information is provided
only in the event that this system will be used in another country with different
requirements. The AM and FM frequency coverage and the tuner frequency steps
available in this system are as follows:
To change from the USA broadcast system to another broadcast system proceed
as follows:
1.) If necessary, press the Power button to shut the power ‘Off’.
2.) Press the Mode button 7 times.
The “USA” indicators flash in the display.
3.) While the display is flashing press either the Tuning + ( ) / – ( ) buttons on
the top panel or TUN / buttons on the remote control to alternately
switch among the “USA”, “EU” (Europe), “JP” (Japan) settings.
4.) Press the Mode button to save the setting and exit the setting mode.
USA EUROPE (EU) JAPAN (JP)
AM (520–1710)kHz (522–1620)kHz (522–1629)kHz
10kHz Steps 9kHz Steps 9kHz Steps
FM (87.5–108)MHz (87.5–108)MHz (76.0–108)MHz
0.1MHz Steps 0.05MHz Steps 0.1MHz Steps
iP500_042307.p65 23/4/2007, 17:00 24