Enviro FOCUS EG31-118 - Manual (Page 8)

8
Maintenance And Service
R
OUTINE
M
AINTENANCE
:
At least once a year, run through the following procedures to ensure the system is clean and working
properly. Check the burner to see if all the ports are clear and clean. Check the pilot to make sure it is not
blocked by anything. The pilot flame should be blue with little or no yellow on the tips.
Warning: Clearances must be sufficient to allow access for maintenance and service
Warning: Failure to position the parts in accordance with this manual, or failure to use only parts
specifically approved with this appliance may result in property damage or personal injury.
The venting system must be periodically examined; it is recommended the examination is done by a
qualified agency.
G LASS D OOR R EMOVAL :
Figure 6: Top bolts for glass door.
Turn unit off and wait until the appliance has cooled down.
Remove the decorative fascia or clip-on bay window by lifting it up
and removing it from the slots in the body of the unit.
Undo the two (2)
5 /
16
’’ bolts at the top of the door frame and then lift
the glass and frame, being careful that the glass does not fall out of
the door frame assembly. Install in the reverse order.
Ensure the door is properly fastened after cleaning before attempting
to re-light the appliance.
C
LEANING
T
HE
G
LASS
:
When the fireplace has cooled, remove the face of the fireplace along with the glass. See M
AINTENANCE
A
ND
S
ERVICE
- G
LASS
D
OOR
R
EMOVAL
. Check the gasket material on the back of the glass, making sure that
it is attached and intact.
During a cold start up, condensation will sometimes form on the glass. This is a normal condition with all
fireplaces. However, this condensation can allow dust and lint to cling to the glass surface. Initial paint
curing of the appliance can leave a slight film behind the glass, a temporary problem. The glass will need
cleaning about two weeks after installation. Use a mild glass cleaner and a soft cloth; abrasive
cleaners will damage the glass and plated surfaces. Depending on the amount of use, the glass
should require cleaning no more than two or three times a season. Do not clean the glass when it is
hot.
C
LEANING
T
HE
F
IREBOX
:
Remove the logs carefully, as they are very fragile. Gently remove all the embers and rock wool and place
on a paper towel. Vacuum the bottom of the firebox thoroughly. Carefully clean any dust off the logs and
remove any lint from the burner and pilot. At this time, inspect the burner pan for cracking or severe
warping. If a problem is suspected, contact the dealer. Check the logs for deterioration or large amounts
of soot; a small amount on the bottom side of the logs is normal. Replace the logs and embers as in the
S ECONDARY I NSTALLATION - L OG S ET AND E MBER I NSTALLATION section. If new/more embers and rock wool are
required, contact your nearest ENVIRO dealer.
R
EPLACING THE
G
LASS
:
The glass in the fireplace is a high temperature ceramic. If the glass is damaged in any way, a factory
replacement is required (see P
ARTS
L
IST
). Wear gloves when handling damaged glass door assembly