Electrolux, Leveling the appliance, Connecting to gas supply – Electrolux EEKG5048 User Manual
Page 32
32
electrolux
installation instructions
LPG cookers MUST NOT be
installed below ground level i.e. in a
basement or aboard any boat yacht
or other vessel.
Leveling the appliance
Adjustment to suit floor conditions or
height is obtained by rotating clockwise
or anti clockwise the feet at the front
and rear of the appliance. A spirit level
should be placed on one of the shelves
to confirm the appliance is correctly
leveled.
Connecting to gas supply
This appliance is designed to be
installed with an appliance flexible
connection only.
Supply piping should not be less than
R3/8. Connection is made to the Rc ½
(½” B.S.P.) female threaded entry pipe
located just below the hob level on the
rear left hand side of the appliance.
ONLY LIQUID SEALANTS TO BE
USED WHEN INLET GAS PIPE IS
FITTED I.E.: DO NOT USE P.T.F.E.
SEALANT TAPE.
Carry out a gas tightness test after
connecting to the gas supply.
The gas bayonet connector must be
fitted in the shaded area indicated.
250mm
200mm
650mm
400mm
Take into account that it must be
possible to pull the appliance forward
sufficiently. Ensure the hose does not
become trapped when pushing the
appliance into position.
FLEXIBLE TUBING USED MUST
COMPLY WITH BS.669 CURRENT
EDITION.
LPG flexible connections must be a
type suitable for L.P.G. and be capable
of operation up to 50mbar and carry a
red stripe, band or label.