Elation Professional Power Wash 250B - Manual (Page 24)

Power Wash 250™
©Elation Professionals® Los Angeles, Ca. - wwww.ElationLighting.com - Page 24
3.10.10 Feedback (FEED)
FEED
The POWER WASH 250B™ is equipped with ”APC,” automatic position
correction. This function automatically corrects the Pan and Tilt movement
should the unit lose step or is obstructed and forced to lose step. Press the
Enter button to access the sub-menu. Use the Up and Down buttons to
toggle between “ON” and “OFF” and confirm once more with the Enter
button or use the Mode button to cancel the operation.
3.10.11 Correction of faults (EFLD)
(These functions are reserved for authorized technicians only)
3.11 Error and Information Messages
HEAt This message appears if you try to switch on the lamp within 5
minutes after having switched off (lamp too hot). The message
will appear on the display if the lamp doesn’t ignite within 20
seconds. The fixture will store this command and automatically
ignite the lamp after 5 minutes.
LaeR After two unsuccessful lamp ignition attempts the display will
readout
LAER . This means the lamp could be damaged, the lamp
is missing, the fixture is overheating, or there could be a failure on
the igniter or ballast.
OTMP This error message informs you the fixture was overheating and
the protective relay switched off the lamp. Please look for
possible reasons (fan faulty, air in/outlets blocked or very dirty,
lamp broken or very old, too high ambient temperature. Switch off
the power supply and solve the possible problem.
RsER This message informs you one of the fixtures function was unable
to reset properly (magnetic sensor, stepping motor, driver on the
PCB, cables, etc.). Repair the defect and start the fixture again.
EFLG