Elation Professional Power Wash 250B - Manual (Page 26)

Power Wash 250™
©Elation Professionals® Los Angeles, Ca. - wwww.ElationLighting.com - Page 26
the audio submenu. See page 16 for the menu breakdown.
4.2.3 In the audio submenu choose the audio chase speed, fast or slow. Slow ( ASLW )
will trigger the chase sequence to every two beats, while fast ( AFST ) will trigger
the chase impulse every beat. See page 16 for more details.
4.2.4 Be sure the Master ( MSTR ) function is switched “ON,“ and the SVPT function is
switched “OFF.“
4.2.5 Choose your room size. The size function allows you to choose a the
approximate size of the room ( NORM, BIG, MIDL, SMAL ). The built-in programs will
automatically adjust to your slection to optimize light output for your room.
4.2.6 Use the sound sensitivity knob on the side control panel to make the unit more or
less sensative to sound. Turning the knob in clockwise direction will make the
unit more sensetive to sound, while turning the knob counter-clockwise will make
the unit less sensetive to sound. Note: This unit will react to the low frequiencies
of a sound source, tapping on the fixture or high pitched sound may not trigger
the fixture.
4.3 Master-Slave Operation (Sound Active): This function will allow you to link up to
16 fixtures together and operate without a controller. The fixtures will be sound
activated. In Master-Slave operation one fixture will act as the controlling fixture
and the others will react to the controlling fixtures programs. Any fixture can act as
a Master or as a Slave.
4.3.1 Using standard XLR microphone cables, daisy chain your fixtures together via
the XLR connector on the rear of the fixtures. Remember the Male XLR
connector is the input and the Female XLR connector is the output. The first
fixture in the chain (master) will use the female XLR connector only - The last
fixture in the chain will use the male XLR connector only. For longer cable runs
we suggest a terminator at the last fixture
4.3.2 Follow the same procedures listed in the previous Stand-Alone section. With two
exceptions; Be sure the first unit in the chain is selected as the “master“ ( MSTR ) is
turned on in the audio submenu. All other fixtures must be in “slave“ mode ( SVPT )
turned on in the audio submenu.