Enviro C-11089 - Manual (Page 14)

Figure 20: Burner Removal.
Figure 19: Unfastening Burner.
Maintenance And Service
F
UEL
C
ONVERSION
:
TO BE INSTALLED BY A QUALIFIED SERVICE AGENCY ONLY
Please read and understand these instructions before installing.
Warning: This conversion kit shall be installed by a qualified service agency in accordance
with the manufacturer’s instructions and all applicable codes and requirements of the
authority having jurisdiction. If the information in these instructions is not followed
exactly, a fire, explosion or production of carbon monoxide may result causing property
damage, personal injury or loss of life. The qualified service agency is responsible for
the proper installation of this kit. The installation is not proper or complete until the
operation of the converted appliance is checked as specified in the manufacturer’s
instructions supplied with the kit.
Kit Parts List:
1 - Orifice (Natural Gas #42 DMS or Propane #54 DMS)
1 - Conversion label 1 - Installation instruction sheet
Carefully inspect the orifice supplied with this conversion kit. If it has been damaged or is missing, contact
your dealer, distributor or courier company to have them replaced before starting this installation.
Conversion Kit Installation:
1. Shut the gas supply off at the shut-off
valve upstream of the unit. CAUTION:
The gas supply must be shut off prior to
disconnecting the electrical power and
before proceeding with the conversion.
Allow the valve and unit to cool down to
room temperature.
Figure 21: Orifice Removal. Figure 22: Orifice
Replacement.
2. Remove the glass door as shown in the M AINTENANCE AND
S
ERVICE
- G
LASS
D
OOR
R
EMOVAL
.
3. Carefully remove the log set and ember material if they
are installed.
4. Using a T-20 screwdriver, remove the four (4) screws
that hold the burner in place (pointed out in Figure 19).
Slide the burner to the left (see Figure 20), then up and
out of the firebox.
5. Convert the burner orifice:
a) Remove the main burner orifice with a
1⁄2 inch deep socket (see Figure 21).
b) Put a bead of pipe-thread sealant or
approved Teflon tape on the orifice threads
before installing into the brass elbow.
c) Install the new orifice from the kit into
the brass elbow (see Figure 22).
6. Convert the pilot:
a) Using a 7 /
16
” wrench, turn the pilot
head a 1⁄4 turn counter-clockwise (shown in
Figure 23).
14