Initial installation – Enviro C-11089 User Manual

Page 23

Advertising
background image

23

Initial Installation

QUALIFIED INSTALLERS ONLY

R

EMOTE

H

ANDSET

W

ALL

B

RACKET

I

NSTALLATION

:

Kit Contents:

Quantity

Description

1

Wall Bracket (Top & Bottom)

1

Spacer

1

Countersink Head Screw

2

Pan Head Screw

2

Spacer

Installation Options:

1. Mounted to wall with bottom of bracket only; refer to Figure 42.

42: Wall Bracket

Installation Option 1.

Figure 43: Wall Bracket Installation

Option 2.

Figure 44: Wall Bracket

Installation Option 3.

Note: The spacer maybe found between the top and

bottom halves of the wall bracket.

IMPORTANT:

The remote handset wall

bracket must be installed

in the same room as the

Sonnet.

2. Mounted to wall with top and bottom

of bracket; refer to Figure 43 (most

common).

3. Mounted to wall and bottom of light

switch cover

with top and

bottom

of

mount; refer

to Figure 44.

The height for the vent must be between 10ft (3.05m) and 35ft (10.67m).

Install sealed Vertical Vent Cap to prevent leakage of room air up through

chimney.

The intake is 2" (51mm) and the exhaust is 3" (76mm).

Measure the height of the chimney beforehand and purchase the

appropriate kit. Never attempt to over-stretch a flexible liner to

accommodate the height of the chimney. Any chimney over 15' (4.6m),

install the Sonnet 15’ 2” & 3” Flex Vent (part #50-1512) and the Sonnet

2” & 3” Flex Couplers (part #50-1513). Every joint in the venting must be

secured with three (3) #8 x 3/8” HWH sheet metal screws and an

appropriate sealant (either silicone or milpac).

The flue damper can be fully blocked open or removed for installation of

the Sonnet; the smoke shelves, shields and baffles may be removed if

attached by mechanical fasteners.

The chimney must be clean, in good working order and constructed of

non-combustible materials.

Make sure that all chimney cleanouts are tight fitting and will not permit

air to leak into the chimney.

Refractory, glass doors, screen rails, screen mesh and log grates can be

removed from the fireplace before installing the Sonnet.

Figure 41: Installation of Sonnet DV .

Advertising
This manual is related to the following products: