Henny Penny OFE- 290 - Manual (Page 15)

Model OFE- 290
3-14. PROGRAMMING 1. Press and hold the FUNCTION button for two seconds.
“REG PROGRAM” shows in the display, followed by
“CODE”.
2. Press the code1-2-3. “SELECT PRODUCT” scrolls
across the display.
If no buttons are pressed, within approximately 1 minute
while in the Program Mode, the controls will revert back
to the Cook Mode.
3. Press the appropriate product button, (1-0), to identify
what product you want to program.
4. “INT1” and “TIME” flashes on the left side of the display.
The right side shows the starting time of the Cook Cycle and
can be changed by pressing the appropriate numbers. Ex:
Press 1,0,0,0 and 10:00 flashes on the right side of the
display, setting the start time at 10 minutes.
5. After setting the time, press and release the FUNCTION
button and “INT1” and “TEMP” flashes on the left side of the
display. The right side shows the starting temperature and can
be changed by pressing the appropriate numbers. Ex: Press
2,5,0 and “250° F” shows onthe right side of the display,
setting the start temperature at 250° Fahrenheit.
6. After setting the temperature, press and release the FUNC-
TION button and “INTI”, “LOAD”, and “COMP” flashes on
the left side of the display. The factory preset load compen-
sation value shows in the right side of the display.
703 3-15