Henny Penny OFE- 290 - Manual (Page 16)

Model OFE- 290
7. After the load compensation, press and release the FUNC-
TION button. “PROP” and “CONTROL” shows on the
left side of the display and the factory preset proportional
control temperature shows on the right side of the display.
8. After the proportional control, press and release the
FUNCTION button. “ALM 1” and “TIME” flashes in the left
side of the display, and the first alarm time shows on the right
side of the display. To change the time the alarm sounds,
press the appropriate product buttons to set the time. Ex:
Press 1,0,0,0. 10:00 flashes on the right side of the display,
which means when the timer counts down to 10 minutes, an
alarm sounds.
9. After alarm is set, press and release the FUNCTION button.
“ALM 1”, “SELF-’’, and “CANCEL” flashes in the left side
of the display and “YES” or “NO” shows on the right side of
the display. The yes and no can be toggled by pressing any of
the product buttons, (l -0). “YES” means the alarm tone
automatically stops after several beeps. “NO” means some
one must manually press the appropriate product button to
stop the alarm tone.
10. Repeat steps 9 and 10 for alarms 2 and 3.
11. After alarm 3 is set, press and release the FUNCTION
button. “FILTER” and “CYCLES” show on the left side of
the display and the Filter Cycle value is on the right side of the
display. The value is the number of Cook Cycles that must
completed before the control signals the operator that the
shortening needs filtered.
12. After the filter value is set, press and release the
FUNCTION button. “EOC” and “EXIT” flashes on the left
side of the display and “COOL” shows on the right side of
the display. The end-of-cycle, (EOC), exit point can be set
to COOL, SETP, or FLTR, by pressing any of the product
buttons (EOC). At the end of a Cook Cycle the controls can
be set to return to Cool Mode, the setpoint temperature, or to
signal the operator to filter the shortening.
3-16 703
3-14. PROGRAMMING
(Continued)