Heath Zenith 598-1214-03 - Manual (Page 2)

2 598-1214-03
Code settings
Note: Most single system installations will
not require any change to the code setting.
transmitter(s) and receiver(s) must have
the same code and group setting to work
together. switches 1 through 3 set the code.
switch 4 sets the group (a or B). see Code
Switch Locations for switch locations.
Transmitter(s)/
Receiver(s) Code
Group B
Transmitter(s)/
Receiver(s) Code
Group A
Example 1 - Code Switch Settings, System 1
(Factory Setting)
ON
1 2 3
4
ON
1 2 3
4
Warnings
• FOR USE ONLY with 120 volt incandescent
or halogen bulbs.
• DO NOT USE with fluorescent bulbs, appli-
ances, power supplies, low voltage lighting, or
any other electrical devices.
( – Indicates Position of Switch)