HP vs80 - Manual (Page 21)

Chapter 1 Installing the Autoloader 21
Preparing the Host and Verifying the Connection
If necessary, install a SCSI host adapter, software, and compatible driver(s).
Refer to the manuals for the host computer and SCSI host adapter for detailed
instructions. In addition, follow these general guidelines:
■
When the host server is powered on, install software, and/or driver(s) that
are compatible with the autoloader.
— Software compatibility information is available at:
http://www.hp.com/go/automated
Most backup software packages require an additional module to
communicate with the autoloader robotics.
— Drivers may be needed for the autoloader to operate properly with your
operating system. To see if drivers are needed for your operating
system, visit HP Customer Care at:
http://www.hp.com/go/support
Select your product, and then click on [download drivers and
software].
■
If the host server is connected to a network, check with the system
administrator before turning off power.
■
Use proper procedures to prevent electrostatic discharge (ESD). Use wrist-
grounding straps and anti-static mats when handling internal components.
■
Make sure that the host server has an open expansion slot.
■
Make sure that both your operating system and server supports the SCSI
host adapter.
■
Depending on the server configuration, you may need to change the SCSI
ID of the autoloader. See Changing the SCSI ID on page 41 for more
information.
■
Ensure the autoloader is properly terminated. If the autoloader is the only
SCSI device - other than the SCSI host adapter - on the selected SCSI bus, it
must be terminated. Likewise, if the autoloader is physically the last SCSI
device on the SCSI bus, it must be terminated. Only the devices physically
at the beginning and end of the SCSI bus should be terminated.