HP vs80 - Manual (Page 66)

66 Diagnostics and Troubleshooting Chapter 4
Autoloader Error Codes
If an error occurs during operation of the autoloader, the autoloader stops the
current operation and displays an error code on the top line of the LCD screen.
Unless otherwise noted in Table 5 , attempt to resolve the error by cycling
power on the autoloader and retrying the last operation. If the error persists,
contact support personnel.
Note When the error appears on the LCD screen, it will show as error
“81”, for example. When you view the error from within the
error log, it will show as “3 0 81”.
To view the error log follow these steps:
1. From the Home Screen or main menu, press the [+] or [-] button until
Information appears on the top line of the LCD screen.
2. Press the [Enter] button to access the available options.
3. Press the [+] or [-] button until View Error Log appears on the LCD screen.
4. Press the [Enter] button to access the most recently logged error message.
5. Press
the [+] or [-] button to display each error in the log.
6. Press [Cancel] when done.
A description of each of the error codes is provided in the following table:
Table 5 Error Codes
Error Code Description Details
3 0 81 Invalid command error. This error indicates that the autoloader received
an undefined command or an invalid parameter
with a command.
3 0 82 Device status not suitable to
execute this command.
If the robotics are busy, some commands cannot
be executed at the same time. This error indicates
a probable violation. This is not an error
condition, but does result in busy being
reported to the host for the requested SCSI
command.