HP vs80 - Manual (Page 8)

8 Installing the Autoloader Chapter 1
Installation Overview
Installing the autoloader consists of the following steps, which are explained in
more detail later in this chapter:
1. Choose a location for the autoloader (
page 12 ).
2. Unpack and check the autoloader for shipping damage ( page 13 ).
3. Identify the accessories that come with the autoloader ( page 14 ).
4. Install the autoloader in a computer rack or select a table or desktop near
the host server ( page 16 ).
5. Shut down, turn off, and remove power from the server and all devices
attached to the server ( page 19 ).
6. Attach the SCSI cable to the autoloader and server’s SCSI host adapter
( page 19 ).
7. Attach the power cable to the autoloader and plug in the power cable to
the nearest power outlet ( page 19 ). Power the autoloader on to ensure it
passes the power-on self test.
8. Set the SCSI ID for the autoloader (if necessary, page 41 ).
9. Set up the host and verify the connection ( page 21 ).