HP vs80 - Manual (Page 50)

50 Autoloader Administration Chapter 3
Note Errors will show as “X X YY”. “YY” represents the specific error
code, and “X X” represents non pertinent address codes.
Additionally, errors range from 0 to -63, where 0 is the newest
error and -63 is the oldest.
Firmware Revision
This option displays the revision of the firmware currently installed in the
autoloader.
Note The tape drive and autoloader firmware is a single image, but
displays as three firmware numbers on the front panel. (An
example is 5000 8000 0102.)
To use this option, follow these steps:
1. From the Home Screen or main menu, press the [+] or [-] button until
Information appears on the top line of the LCD screen.
2. Press the [Enter] button to access the available options.
3. Press the [+] or [-] button until Firmware Rev appears on the LCD screen.
The LCD screen displays the revision of the firmware currently installed in
the autoloader.
4. Press [Cancel] when done.
Note After a firmware update, the firmware revision displayed on the
LCD will not be updated until the autoloader is power cycled.