HP INTEGRITY RX3600 - Manual (Page 110)

6. Power on the enclosure.
7. Power on the server.
SAS Cable Part Numbers
If you require additional cables, order them by the option kit number listed in Table 3-16 .
Table 3-16 SAS Cable Part Numbers
Cable Assembly Number Option Kit Number Cable Length
361317-001 389664-B21 1.0 m (3.3 ft.)
361317-002 389668-B21 2.0 m (6.6 ft.)
361317-004 389671-B21 4.0 m (13 ft.)
361317-006 389674-B21 6.0 m (20 ft.)
SAUPDATE Utility
Use saupdate from the EFI Shell to update the firmware image on the HP Smart Array Controller.
Command line options are described below. Follow one of these two procedures to run saupdate:.
• If you are using saupdate from the Offline Diagnostic CD:
1. Download the firmware and copy it to the EFI partition.
2. The CD containing saupdate.efi must be in the drive before booting the system to allow
device mapping.
3. Boot the system to the EFI Shell prompt. The CD drive should appear in the list of mapped
devices as fs0.
4. Change to this device by typing fs0: under EFI Shell prompt.
5. If the EFI utility and firmware image files are not located in the root directory, move to the
directory in which these files are located, for example:
fs0: >cd EFI HP TOOLS IO_CARDS SmartArray
IMPORTANT: Both saupdate.efi and the firmware image file must be located in the same
directory. If they are not, copy them both to the EFI partition. Run the saupdate.efi using the
fs0: > saupdate
command.
• If you are not using the Offline Diagnostic CD:
1. Download the SA EFI update utility saupdate.efi and copy it to the EFI partition.
2. Download the firmware and copy it to the EFI partition.
3. Boot the system to the EFI Shell and change directories to the EFI partition.
4. Run the saupdate.efi using the using the fs0:\> saupdate.efi command.
The following screen displays. The version of the utility displays on the second line:
*************************************************************
Smart Array Offline Firmware Update Utility
Version: 1.04.12.00
(C) Copyright 2004 Hewlett Packard Development Company L.P.
*************************************************************
Syntax
saupdate <operation> <parameters>
Commands
You can use the following operations with saupdate:
110 Installing the System