Specifying scsi parameters, Using the scsi setup utility, D-24 – HP INTEGRITY RX3600 User Manual
Page 337: Sysmode, Command
Advertising
Example D-24 sysmode command
Shell> sysmode
System Mode: NORMAL
Shell> sysmode admin
You are now in admin mode.
Shell> sysmode service
You are now in service mode.
Shell> sysmode normal
You are now in normal mode
Specifying SCSI Parameters
The following SCSI parameters can be configured for the SCSI board:
•
SCSI ID (SCSI initiator ID)
•
Maximum data transfer rate (SCSI rate)
•
Bus width
•
Whether the HBA is bootable (driver support)
•
Avoid bus resets (secondary cluster server)
Using the SCSI Setup Utility
To use the SCSI Setup Utility to specify SCSI parameters, follow these steps:
Specifying SCSI Parameters
337
Advertising